Special For Exploration Drilling Rig Mud Pump
Brief Introduction Of Drilling Rig Mud Pump
BW160 Hydraulic Triplex Plunger Drill Rig Mud Pump is a horizontal single-cylinder double-acting reciprocating piston pump, the pump head is equipped with four 40mm steel ball valve, thereby increasing the pressure. It is mainly used to provide flushing solution in blasting hole in geophysical prospecting. It can also be used to supply flushing liquid into well in bedrock drilling of engineering geological drilling rig. The pump has the characteristics of small volume, light weight and durability, and is more suitable for geological exploration.
Application Of Drilling Rig Mud Pump
1.Projects: Construction drilling of the projects e.g. prospection, geotechnical investigation(geological exploring), railway, road, port, bridge, water conservancy and hydropower, tunnel, well, industrial and civil construction;
2. Exploration: Coal mining exploration, Ore exploration;
3. Water well : Small hole diameter water well drilling;
4. Pipe-installing : Geothermal pipe-installing for heat pump;
5. Foundation piling: Small-diameter hole foundation piling drilling.
Parameter Of Drilling Rig Mud Pump
| Pump Type | Horizontal |
| Type of action | Double Acting |
| cylinders | 1 |
| Cylinder diameter (mm) | 95 |
| Stroke (mm) | 85 |
| Number of reciprocations (times / minute) | 165 |
| Displacement (liters / min) | 160 |
| Working pressure (MPa) | 1.6 |
| Transmission shaft speed (r / min) | 951 |
| V - belt pulley diameter (mm) | 270 |
| V-belt pulley type and slot number | B-type × 3 slot |
| Transmission power (kW) | 7.5 |
| Diameter of suction pipe (mm) | ø45 |
| Drain pipe diameter (mm) | ø38 |
| Overall dimensions (L* W* H) (mm) | 1110* 800*950 |
| Weight (not including power machine) (kg) | 136 |
| Motor Y132M-4 Power | 7.5KW |
| Speed | 1440r / min |
| Diesel Engine R180 Power | 5.67KW |
| Diesel Engine Speed | 2600r / min |
Precautions for Drilling Rig Mud Pump
- (1) Always pay attention to the indication of pressure gauge. If the indication of pressure gauge or the safety device does not work after exceeding the pressure, find out the reason and clear the fault
- Restart.
- (2) Pay attention to whether the structure of the mortar pump and motor is normal. When any fault is found, stop the pump immediately and open the discharge valve to reduce the pressure and eliminate the fault.
- (3) Attention should be paid to make the gland press the packing to avoid leakage. If there is still leakage after pressing, the packing or piston should be replaced according to the specific situation.
- (4) The consistency of the mixed mortar shall be measured before entering the pump. During the test, the consistency meter shall be vertical to the slurry surface, and it shall be laid down easily to sink with its own weight.
- (5) At the end of each shift, clean water must be pumped immediately, and the pipeline and pump interior must be cleaned until the ball valve, discharge port, suction port and discharge port are ensured
- The valve is clean and smooth.
- (6) The upper chamber should be filled with oil.
Product Tags:
|
|
BW160 Mud Pumps For Drilling Rigs Images
|
